Coralife Bio Cube Instruções de Operação descarregar pdf (Página 12)

Installing the Heatsink

The heatsink attaches to the plastic posts already in the hood via 6 screws. The screws are the large

screws included with the kit. Tighten gently until heatsink is snug. Tightening them more than this may

strip out the plastic screw bosses in the hood at which point you will have fill the stripped bosses with a

hard glue or epoxy and drill them back out so the screw will grip again, or find some other solution.

Over tightening may also snap the screw bosses from the hood, in which case, you will have to attempt

repair with super glue.

For this retrofit, it is easiest to line up one of the rearmost screws and screw it in first. Next, rotate the

heatsink around this screw until you can drop the other three rear screws into their mounting holes. Be

patient, they will line up. Once they line up, screw them all in. Note the two screws furthest from the

rear of the hood are not screwed in yet – they go last.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sem comentários

Coralife Bio Cube Instruções de Operação Página 12